NETW 204 Week 7 Quiz | Assignment Help | Devry University
- Devry University / NETW 204
- 03 Jul 2019
- Price: $7
- Other / Other
NETW 204 Week 7 Quiz | Assignment Help | Devry University
Question
1
(TCO 6)
Which DHCPv4 message will a client send to accept an IPv4 address that is
offered by a DHCP server?
Question
2
(TCO 6) This layer 2 address is used when a
DHCP client makes a request to a DHCP server for an IPv4 address.
Question
3
(TCO 6) An administrator issues the following
commands.
Ro1(config)# interface F0/3
Ro1(config-if)# ip address dhcp
What is the administrator trying to achieve?
(TCO 6) A PC is configured to use the SLAAC
method to obtain an IPv6 address. What message does the PC receive from the
router after sending an RS message?
Question
5
(TCO 7) What is the group of RFC1918 IPv4 addresses
used within an organization's network on a NAT-enabled router known as?
Question
6
(TCO 7) Which type of NAT allows a pool of IP
addresses to be used to access computing resources on the Internet?
Question
7
(TCO 6) The command that must be entered on a
router to enable IPv6 routing is _____.
Question
8
(TCO 6) The command to configure a router into
a DHCP IPv6 Relay Agent on an interface is _____.
(TCO 7) The command one can issue on a router
to see active NAT translations is _____.
Question
10
(TCO 6) When a DHCP client first boots up and
needs to be assigned an IP address it sends out a packet to a DHCP server in
the form of a(n) _____.
Question
11
(TCO 7) The command someone can enter on a
router to generate a description of each packet considered for translation is
_____.
Question
12
(TCO 6) Which command excludes the last 10
useable IP addresses from a DHCPv4 address pool of the network 172.16.15.64/26?